Many businesses are now opting for a more permanent hybrid working environmen...

There are two different versions of mechanical seams: Single lock 90-degree seams and double lock 180-degree seams. What this does, is highly reduces the chance that any standing or running water comes in contact with the seam, doing its job in the . With standing seam metal roofing, specifically flat panels, it can be easier to see scratches. Furthermore, standing seam systems are manufactured from high-end steel or aluminum offering years of low-maintenance service life. For larger-sized orders, metal panels can cost less than $4.50 per square foot including trim. Mirage II can be installed oversoliddeck or substructural members. February 23 - 24, 2023. In order to take advantage of the benefits of SSR, it is necessary for each designer to choose, specify, and detail the correct product for every installation. If your house is located in close proximity to salt spray environment such as a beach house, then your best bet is to go with an aluminum roof that is coated with Kynar 500 or equivalent-quality paint finish. Snap-lock systems should only be installed on roof pitches (slope) of 3/12 and above unless otherwise approved by the manufacturer. Mirage II can be installed over. Note: Never buy low-cost metal panels finished with acrylic or polyester only paint finish for residential applications. The main idea for standing seam systems is that the fastener is hidden, whether the panel isattached to the roof deck using a clipor is directly fastened to the decking material under the vertical leg (fastener flange). Through training, installation and warranty work, our company is the only consistent earner of GAF's Triple Excellence Award in the Kansas City area. They look very similar, but if you look closer at the Snap-Lock 550, it not only utilizes a clip for performance, but has significant bends in the male leg of the metal for even better performance. AIA Metal Roofs: Wind Uplifting or Not? Verification of attendee having been actively involved in the installation of metal building products for a minimum of three years immediately preceding attendance to the course. Consequently, non-symmetrical systems can require the removal of unaffected panels during building repairs or modifications. Single lock refers to ONE fold of the seam (or 90 degrees). Standing seam systems attach to the substructure with concealed fasteners. These flatter pitches do not allow water to adequately drain, which could lead to premature degradation, color changes, and the overall failure of the panel system. Early Van Halen Signal Chain, Randy Scott Saxophonist, Articles S

In this issue, we will talk about some important skills needed for office par...